admin
dac37fd077
Make sure docs are updated / settings_md (push) Canceled after 0s
Build firmware / test (push) Canceled after 0s
Build firmware / build-SITL-Windows (push) Canceled after 0s
Build firmware / build-SITL-Mac (push) Canceled after 0s
Build firmware / build-SITL-Linux (push) Canceled after 0s
Build firmware / build-SITL-Linux-arm64 (push) Canceled after 0s
Build firmware / upload-artifacts (push) Canceled after 0s
Build firmware / build-single-target (push) Canceled after 0s
Build firmware / build (9) (push) Canceled after 0s
Build firmware / build (8) (push) Canceled after 0s
Build firmware / build (7) (push) Canceled after 0s
Build firmware / build (6) (push) Canceled after 0s
Build firmware / build (5) (push) Canceled after 0s
Build firmware / build (4) (push) Canceled after 0s
Build firmware / build (3) (push) Canceled after 0s
Build firmware / build (2) (push) Canceled after 0s
Build firmware / build (14) (push) Canceled after 0s
Build firmware / build (13) (push) Canceled after 0s
Build firmware / build (12) (push) Canceled after 0s
Build firmware / build (11) (push) Canceled after 0s
Build firmware / build (10) (push) Canceled after 0s
Build firmware / build (1) (push) Canceled after 0s
Build firmware / build (0) (push) Canceled after 0s
Build firmware / detect (push) Canceled after 0s
Build pre-release / build (push) Canceled after 0s
Build pre-release / Release (push) Canceled after 0s
19 lines
665 B
Markdown
19 lines
665 B
Markdown
# SpeedyBee F405 V3
|
|
|
|
> Notice: DSHOT on SpeedyBe F405 V3 requires INAV 7.0.0 or later. If you are using an older version, use MULTISHOT instead.
|
|
|
|
> Notice: The analog OSD and the SD card (blackbox) share the same SPI bus, which can cause problems when trying to use analog OSD and blackbox at the same time.
|
|
|
|
## Flashing firmware
|
|
|
|
We often see reports of users having problems flashing new firmware with this baord. The following sugestions usually seem to fix the issues.
|
|
|
|
* Remove SD Card
|
|
* Disconnect devices from UART1 and UART3
|
|
|
|
Try removing the SD Card first, and if that still does not fix the issue, disconnect the devices connected to UART1 and UART3.
|
|
|
|
|
|
|
|
|