admin
dac37fd077
Make sure docs are updated / settings_md (push) Canceled after 0s
Build firmware / test (push) Canceled after 0s
Build firmware / build-SITL-Windows (push) Canceled after 0s
Build firmware / build-SITL-Mac (push) Canceled after 0s
Build firmware / build-SITL-Linux (push) Canceled after 0s
Build firmware / build-SITL-Linux-arm64 (push) Canceled after 0s
Build firmware / upload-artifacts (push) Canceled after 0s
Build firmware / build-single-target (push) Canceled after 0s
Build firmware / build (9) (push) Canceled after 0s
Build firmware / build (8) (push) Canceled after 0s
Build firmware / build (7) (push) Canceled after 0s
Build firmware / build (6) (push) Canceled after 0s
Build firmware / build (5) (push) Canceled after 0s
Build firmware / build (4) (push) Canceled after 0s
Build firmware / build (3) (push) Canceled after 0s
Build firmware / build (2) (push) Canceled after 0s
Build firmware / build (14) (push) Canceled after 0s
Build firmware / build (13) (push) Canceled after 0s
Build firmware / build (12) (push) Canceled after 0s
Build firmware / build (11) (push) Canceled after 0s
Build firmware / build (10) (push) Canceled after 0s
Build firmware / build (1) (push) Canceled after 0s
Build firmware / build (0) (push) Canceled after 0s
Build firmware / detect (push) Canceled after 0s
Build pre-release / build (push) Canceled after 0s
Build pre-release / Release (push) Canceled after 0s
31 lines
1.0 KiB
Markdown
31 lines
1.0 KiB
Markdown
# Board - [MATEKSYS F411-Wing](https://inavflight.com/shop/p/MATEKF411WING)
|
|
|
|
|
|
|
|
## Specification:
|
|
|
|
* STM32F411 CPU
|
|
* OSD
|
|
* BMP280 barometer
|
|
* Integrated PDB for 2 motors
|
|
* 2 UART ports
|
|
* 5 servos
|
|
* no SD card slot
|
|
* 3 BECs
|
|
|
|
## Details
|
|
|
|
* [Full specification](http://www.mateksys.com/?portfolio=f411-wing)
|
|
* SBUS pad has a built-in inverter and is connected to UART1 RX
|
|
|
|
## Available TARGETS
|
|
|
|
* `MATEKF411` if you want to control LEDs and have SS1 TX on ST1 pad.
|
|
* `MATEKF411_FD_SFTSRL` if you need the softserial to be full-duplex (TX = ST1 pad, RX = LED pad), at the cost of losing the LED output.
|
|
* `MATEKF411_RSSI` if you want to have analog RSSI input on ST1 pad. SS1 TX will be available on the LED pad.
|
|
* `MATEKF411_SFTSRL2`if you want to use two softserials (TX only) at the same time. Eg. Smart Audio + S. Port, Smart Audio + LTM. (SS1 TX will be on ST1 pad and SS2 TX will be on LED pad).
|
|
|
|
## Where to buy:
|
|
|
|
* [Banggood](https://inavflight.com/shop/p/MATEKF411WING)
|