admin
dac37fd077
Make sure docs are updated / settings_md (push) Canceled after 0s
Build firmware / test (push) Canceled after 0s
Build firmware / build-SITL-Windows (push) Canceled after 0s
Build firmware / build-SITL-Mac (push) Canceled after 0s
Build firmware / build-SITL-Linux (push) Canceled after 0s
Build firmware / build-SITL-Linux-arm64 (push) Canceled after 0s
Build firmware / upload-artifacts (push) Canceled after 0s
Build firmware / build-single-target (push) Canceled after 0s
Build firmware / build (9) (push) Canceled after 0s
Build firmware / build (8) (push) Canceled after 0s
Build firmware / build (7) (push) Canceled after 0s
Build firmware / build (6) (push) Canceled after 0s
Build firmware / build (5) (push) Canceled after 0s
Build firmware / build (4) (push) Canceled after 0s
Build firmware / build (3) (push) Canceled after 0s
Build firmware / build (2) (push) Canceled after 0s
Build firmware / build (14) (push) Canceled after 0s
Build firmware / build (13) (push) Canceled after 0s
Build firmware / build (12) (push) Canceled after 0s
Build firmware / build (11) (push) Canceled after 0s
Build firmware / build (10) (push) Canceled after 0s
Build firmware / build (1) (push) Canceled after 0s
Build firmware / build (0) (push) Canceled after 0s
Build firmware / detect (push) Canceled after 0s
Build pre-release / build (push) Canceled after 0s
Build pre-release / Release (push) Canceled after 0s
1.3 KiB
1.3 KiB
YuPiF4 by RcNet
An high quality flight controller for the most demanding pilotes.
Description
The YuPiF4 is a 36x36mm (30.5x30.5 mounting holes) board with an F4 microcontroller.
MCU, Sensors and Features
Hardware
- MCU: STM32F405RTG6
- IMU: not yet defined
- IMU Interrupt: Yes
- BARO: No
- VCP: Yes
- Hardware UARTS: 3 with an inverter for SBus and a Smart-Port Pad to solder directly your SPort wire
- Blackbox: SD card slot
- PPM : A specific pad is available for PPM input
- Battery Voltage Sensor: Yes, directly connected, no wiring necessary
- Integrated Voltage Regulator: the board can be powered by your lipo (2S to 6S)
- Brushed Motor Mosfets: No
- Motor outputs : can drive up to 6 motors
- Buttons: Boot0 to enter in DFU mode### Features
- Current Sensor: Not implemented
- BlHeli passthrough: Yes
- WS2811 Led Strip: Yes (on motor output Pin 5)
- Transponder: No
Extension Board
- An extension board with a GPS and a Baro will be available
Designers and Maintainers
Manufacturers and Distributors
This board is currently in the prototype phase. Only small batches were manufactured for testing.Website : http://www.yupif4.com/